麻豆精品在线_韩国巨胸女三级视频网_韩国免费毛片在线看_36漫画在线

A stepper motor is a device that converts electrical energy into kinetic energy. There are many types of it. The phenomenon and cause of damage to different types of stepper motors will be different, but in summary, it is nothing more than two categories: electrical and mechanical.

Issues in selection and installation：

1. The level between the stepper motor and the load is not adjusted properly, resulting in radial impact due to the disagreement between the load and the stepper motor.

2. The screws for stepping motor installation are not fixed properly, or the fixing frame is not designed well.

3. When supplying power, the problem of the withstand voltage of the stepper motor was not considered. For example, 220 volts were used, and 380 volts were used to enter it.

4. Some stepper motors and servo motors cannot be disassembled privately to replace bearings or the like, otherwise the magnetic field may be lost or the encoder magnetic pole zero offset may not be used normally.

5. The load needs some special brakes. The stepper motor is not equipped with brakes, so it may not be able to release the energy when it stops.

6. The stepper motor is not designed with some protection devices, such as overheating, overload, overtemperature, and lack of equalization. These may happen during use, but because the protection is not in place, the stepper motor will be burned directly.

7. The load condition is not taken into consideration when selecting the model. Some loads start and stop frequently, and may only need 10W of power. Considering heat dissipation and weakness in the design, a 30W motor may be required.

8. The wiring is wrong, for example, the star connection is connected to the triangle, and the triangle is connected to the star, which may cause overheating inside the motor.

9. The wiring is wrong, or the front and back are reversed, or the wire is selected thin, or the terminal lug is not pressed well, resulting in excessive contact resistance.

10. If you use a photoelectric encoder or the like, you need to consider some dust protection and anti-collision protection.

11. The driver is broken, causing the stepper motor to burn out due to instantaneous high voltage or high current.

Gear issues：

1. Insufficient lubricating oil, aging or adding too much, the lubricating oil should not exceed 70% of the volume of the bearing cap and bearing.

2. The installation is not in place, such as the bearing and the bearing cover are too tight or too loose. The concentricity is not right, and there is eccentric force causing damage.

3. The level of the coupling is not adjusted properly, the gears or synchronous belts between the transmissions are too tight, and the shaft is impacted and deformed by the load force.

4. The quality of the bearing is not good, and the clearance of the bearing is too small or too large.

5. There are impurities such as iron powder in the lubricating oil, or the oil ring inside is stuck.

Quality Issues：

1. The copper wire of the coil winding is unqualified, or the number of turns is not enough, or there are problems such as different resistance values of each phase.

2. For some permanent magnet motors, the magnetic material is not resistant to high temperature and loses magnetism after a period of use.

3. The insulation of the motor is not good. Sometimes the power grid voltage of the factory power supply is too high, and the voltage fluctuates slightly, causing insulation breakdown.

Environmental issues of stepper motors：

1. For high-temperature occasions, such as over 50 degrees for a long time, and the load is relatively heavy, when selecting the motor, no high-temperature-resistant motors such as F and H are used, and no separate air cooling system is designed, and the motor temperature is too high for long-term operation.

2. For loads with large vibrations, the problem of resonance should be considered. When fixing the motor, the direction of the screw should consider whether it will loosen due to vibration.